Guidelines for Charging/Using Sypom LiPo Batteries

DRONE, lipo battery, RC DRIVERS, RC HELICOPTER, rc Pilots, sypom, sypom batteries -

Guidelines for Charging/Using Sypom LiPo Batteries

Guidelines for Charging/Using Sypom LiPo Batteries.

Though Sypom Lipo batteries have the advantages of high discharge rate, small inner resistance, high capacity, light weight and low cost. The batteries need to be charged correctly, or accidents may happen.

Here are some guidelines from users, telling our customers how to correctly charge our Lipo batteries.

  1. Use only a charger approved for lithium batteries. The charger may be designed for Li-Ion or Li-Poly. Both batteries are charged in exactly the same. Some older cell phone chargers may charge the batteries . 1 volt to low (4.1 vs 4.2), but that will not harm the battery. However, inexpensive lithium chargers are widely available and the use of cellphone chargers is highly discouraged.
  1. Make certain that the correct cell count is set on your charger. Watch the charger closely for the first few minutes to ensure that the correct cell count continues to be displayed. If you don't know how to do that, get a charger that you do know how or don't charge the batteries.
  1. Use the Taps. Before you charge a new Lithium pack, check the voltage of each cell individually. Then do this after every tenth cycle there after. This is absolutely critical in that an unbalanced pack can explode while charging even if the correct cellcount is chosen. If the cells are not within 0.1 volts of each other then charge each cell individually to 4.2 volts so that they are all equal. If after every discharge the pack is unbalanced you have a faulty cell and that pack must be replaced. Taps are provided on most new lithium packs. Taps give you the ability to check individual cell voltages and charge one cell at a time.  Make sure and get the appropriate connector to go into your taps. Don't try to stick you volt meter probes in the taps to measure voltage. They could slip and short your cells. Don't try to charge more than one cell at a time from the taps. Unless you have an isolated ground charging system, you'll short your batteries out. Refer to your individual cell maker for tap pin-outs.
  1. Never charge the batteries unattended. This is the number one reason for houses and cars being burned to a crisp by lithium fires.
  1. Use a safe surface to charge your batteries on so that if they burst into flame no damage will occur. Vented fire safes, pyrex dishes with sand in the bottom, fireplaces, plant pots, are all good options.